GO Galvanised Malleable Iron Reducing Tee Range Scr BSP BS EN 10242

SKU: LT1508

$2

GO Galvanised Malleable Iron Reducing Tee Range Scr BSP BS EN 10242

DIMENSIONS

Pipe Tee is a type of pipe fitting which is T-shaped having two outlets, at 90° to the connection to the main line. It is a short piece of pipe with a lateral outlet. Pipe Tee is used to connect pipelines with a pipe at a right angle with the line.Pipe Tees are widely used as pipe fittings.

Please note our following guide on sizing and coding for our range of galvanised malleable iron reducing tees

Reducing Fittings Guide

MATERIALS

  • Blackheart Malleable Iron casting.

DIMENSIONS

  • generally to ASME B16.3 or JIS B2301, depending on manufacturing source.
  • JIS B2301 dimensions are generally considered to be corresponding values to BS143 and BS1256, although some sizes are not exact equivalents.

THREADING

  • BSP pipe thread, to BS.21 (AS 1722, Part 1).
  • The specification for BS 143 fittings is:
    • Taper External (Series R) Taper Internal (Series RC)
    • The specification for BS 1256 fittings is:
    • Taper External (Series R) Parallel Internal (Series RP)

FINISH

  • Hot Dip Galvanised is the standard finish for stock.

TESTING

  • Fittings shall be subject to an internal hydraulic pressure of 2068 kPa without showing any sign of leakage or abnormality.

WORKING PRESSURES (except flanges)

  • Recommended maximum working pressures are 1379 kPa for water and 1034 kPa for steam, air, gas and oil. NOTE: Working pressures may also be limited by relevant Pressure Piping Codes or Industry regulations.

UNEQUAL SIZES

  • When ordering Reducing Sockets, Nipples, Bushes and Elbows, always state largest size first — e.g. 80 x 40 bush.  When ordering 3- or 4- way fittings, the sizing sequence illustrated below should be adopted.

 

    You may also like

    Recently viewed